进口Power-Sonic蓄电池PDC-121100 12V107AH

进口Power-Sonic蓄电池PDC-121100 12V107AH

　　Power-Sonic一直是主导力量在电池业务超过46年。由于我们的承诺我们公司蓬勃发展提供高质量的成本有效的电池,支持水平的服务是的。

　　我们骄傲我们的灵活性和能力迅速采取行动为市场带来新的行业产品。我们很自豪持有ISO 9001认证覆盖我们的组织的各个方面。

What is sulfation of batteries?

挪动空调或因装修而要拆空调的用户，那在拆空调前一定要让专业维修人员收氟，并一定要把敞开的管道口和阀门口用原来的丝堵螺帽堵好，要不就用多层塑料布包严。假如一旦进水或进土，结果是很严重的。保温套破损了也要及时修补，否则空调的能效损失也是很多的。

什么状况下要对机房精细空调加氟！

1、运用超越5年以上的（任何一台分体式空调机都会自然走漏氟立昂）；

2、屡次移机的（空调移机排空时会耗费局部氟立昂）；

3、制冷外机衔接点的粗管暴露处（即低压管）不结露或不凉的；

4、制冷外机风扇排风不热的；

5、制冷回气压力（粗管）低于0.4兆帕的；

6、紧缩机运转电流小于铭牌标注正常值的；

7、制冷高压管（细管）结霜的；

8、制冷空调内机结冰或吹雾的（有时分还伴有内机漏水）；

9、制热手摸外机铜管接口处粗管不烫手的；

10、空调有走漏点的；

11、空调开机后十几分钟就停机的（低压维护或过热维护）。

空调缺氟后的现象：

1、气管阀门发干，用手触摸没有明显的凉感。

缘由是制冷剂缺乏招致蒸发器内的沸腾终结点提早，使该阀的制冷剂过度增大，阀门的温度升高，大于室外空气的漏点温度。

2、液管阀门结霜。

缘由是“缺氟”招致液管内压力降落，沸点降低，使阀门温度低于冰点。

3、翻开室内机面板，取下过滤网，可发现局部蒸发器结露或结霜。

缘由是由于制冷剂缺乏，仅仅使局部蒸发器发作了沸腾吸热，使制冷面积相应减少。

4、室外机排风没有热感。

缘由是制冷剂缺乏招致冷凝压力、冷凝温度都降低，排风温度也随之降低。

5、排水软管排水断断续续或基本不排水。

缘由是蒸发器制冷面积减少，结出面积也减少，凝结水量降低。

6、室外机气、液阀门有油污，有油污就有泄露。

缘由是制冷剂与冷冻油有一定的互溶性，氟从漏点逸出后进入大气中，而油附着在漏点四周。

7、丈量空调器的工作电流小于额定电流。

缘由是制冷剂缺乏而使紧缩机工负荷减少，电流降落。

8、从室外机充氟口丈量的压力低于0.45Mpa.

缘由是制冷剂缺乏招致了蒸发压力降落。

空调缺氟的简易判别办法

一台装置合格不走漏的空调，三五年，七八年都能够不加氟。反之，三两天就可能漏光。如何判别空调缺氟呢？

一试——

空调机正常开启一段时间后吹到身上的风感到很凉，并能很快到达设定温度，室外机的紧缩机能像电冰箱一样开一会儿关一会儿，就能够说是正常。

二测——

用温度计丈量室内机的进、出口风的温差，差值在10℃以上，也算正常，温差越大阐明格力空调的工况越好，好的可达15℃左右。

Sulfation is the formation or deposit of lead sulfate on the surface and in the pores of the active material of the batteries' lead plates. If the sulfation becomes excessive and forms large crystals on the plates, the battery will not operate efficiently and may not work at all. Common causes of battery sulfation are standing a long time in a discharged condition, operating at excessive temperatures, and prolonged under or over charging.

What are some of the major types of lead acid batteries?
Batteries are divided in two ways, by application (what they are used for) and construction (how they are built). The major applications are automotive, marine, and deep-cycle. Deep-cycle includes solar electric (PV), backup power, and RV and boat "house" batteries. The major construction types are flooded (wet), gelled, and AGM (Absorbed Glass Mat). AGM batteries are also sometimes called "starved electrolyte" or "dry", because the fiberglass mat is only 95% saturated with Sulfuric acid and there is no excess liquid. Flooded may be standard, with removable caps, or the so-called "maintenance free" (that means they are designed to die one week after the warranty runs out). All gelled are sealed and a few are "valve regulated", which means that a tiny valve keeps a slight positive pressure. Nearly all AGM batteries are sealed valve regulated (commonly referred to as "VRLA" - Valve Regulated Lead-Acid). Most valve regulated are under some pressure - 1 to 4 psi at sea level.

蓄电池应用领域与分类：
◆　免维护无须补液；　　　　　　　　　　● UPS不间断电源；
◆　内阻小，大电流放电性能好；　　　　　● 消防备用电源；
◆　适应温度广；　　　　　　　　　　　　● 安全防护报警系统；
◆　自放电小；　　　　　　　　　　　　　● 应急照明系统；
◆　使用寿命长；　　　　　　　　　　　　● 电力，邮电通信系统；
◆　荷电出厂，使用方便；　　　　　　　　● 电子仪器仪表；
◆　安全防爆；　　　　　　　　　　　　　● 电动工具,电动玩具；
◆　*配方，深放电恢复性能好；　　　　● 便携式电子设备；
◆　无游离电解液，侧倒仍能使用；　　　　● 摄影器材；
◆　产品通过CE,ROHS认证,所有电池　　　　● 太阳能、风能发电系统；
符合国家标准。　　　　　　　　　　　● 巡逻自行车、红绿警示灯等。 

What is the "Memory Effect" that I have heard about?
NiCad batteries, and to a lesser extent NiMH batteries, suffer from what's called the "memory effect". What this means is that if a battery is repeatedly only partially discharged before recharging, the battery "forgets" that it has the capacity to further discharge all the way down. To illustrate: If you, on a regular basis, fully charge your battery and then use only 50% of its capacity before the next recharge, eventually the battery will become unaware of its extra 50% capacity which has remained unused. The battery will remain functional, but only at 50% of its original capacity. The way to avoid the dreaded "memory effect" is to fully cycle (fully charge and then fully discharge) the battery at least once every two to three weeks. Batteries can be discharged by unplugging the device's AC adapter and letting the device run on the battery until it ceases to function. This will insure your battery remains healthy.

Do I need to charge my new Laptop or Notebook battery?
A new battery comes in a discharged condition and must be charged before use (refer to the devices manual for charging instructions). Upon initial use (or after a prolonged storage period) the battery may require three to four charge/discharge cycles before achieving maximum capacity. When charging the battery for the first time the device may indicate that charging is complete after just 10 or 15 minutes. This is a normal phenomenon with rechargeable batteries. Remove the battery from the device, reinsert it and repeat the charging procedure.

Do I have to condition my Laptop or Notebook battery?
Yes, it is very important to condition or fully discharge and then fully charge the battery every two to three weeks. Failure to do so may significantly shorten the battery's life (this does not apply to Li-Ion batteries, which do not require conditioning). To discharge, simply run the device under the battery's power until it shuts down or until you get a low battery warning. Then recharge the battery as instructed in the user's manual.

My new laptop battery is not Charging. What is wrong?
New batteries are shipped in a discharged condition and must be charged before use. We generally recommend an overnight charge (approximay twelve hours). Refer to the user's manual for charging instructions. Rechargeable batteries should be cycled (fully charged and then fully discharged) two to four times initially to allow them to reach their full capacity. (Note: it is normal for a battery to become warm to the touch during charging and discharging).

New laptop batteries are hard for the device to charge; they have never been fully charged and are therefore "unformed". Sometimes the device's charger will stop charging a new battery before it is fully charged. If this happens, remove the battery from the device and then reinsert it. The charge cycle should begin again. This may happen several times during the first battery charge. Don't worry; it's perfectly normal.

Is it Possible to Upgrade the Device's Battery to a Newer Chemistry?
NiCad, NiMH and Li-Ion are all fundamentally different technologies and cannot be substituted for one another unless the device has been pre-configured from the factory to accept more than one type of rechargeable battery. The difference between them stems from the fact that each technology requires a different charging pattern to be properly recharged. Therefore, the portable device's charger must be properly configured to handle a given type of rechargeable battery. Refer to your owners manual to find out which rechargeable battery types the particular device supports or use our QuickFind search engine to find the device in our database. The database will automatically list all of the battery types supported by the machine.

合格的安装不漏空调，年，七年或八年不能添加氟。另一方面，可能漏光的天。如何确定氟空调缺乏？
试一试
空调开启一段时间后吹着风在身上感觉很冷，并能迅速达到设定温度，压缩机可以打开一个在冰箱，像一个在冰箱，可以说是正常的。
两测量
用温度计测量室内机入口和出口的温度差，差值超过摄氏度，这也算正常，温差越大，更好的格力空调的工作状态，好的可以达到度左右摄氏度。
三看十分钟后在开机
，打开室内机面板，应看到蒸发器（铜铝板上全热交换元件）与冷凝水均匀，如露水，正常（空气湿度大，少）。如果一半没有，可能是缺乏氟化物。如局部结霜或结冰都不正常。
四摸
如果在手的室外机可触摸的地方，十分钟后可以触摸启动。该室外机有两个铜阀，一个与厚铜管，和一个薄铜管。触摸阀应该有温差两个；粗应低于温度的罚款，感觉相对凉爽的正常（在高温也应冷凝水）。触摸室外风扇不热，如果不热可能是缺氟。
五观测
一半以上的用户，阀门管接头和室外机可以检查室内机漏水迹象明显，渗漏等现象显然表明机器有泄漏，由于溢油会溶解氟、漏氟，漏氟会泄漏。
除了以上，在选型、安装、工作环境都是正常的，或之前的工作是正常的，现在不酷，这可能是缺氟。氟缺乏是zui常见的，但不是*的问题。是不是上述情况必须是缺乏氟化物。而氟化物的增加，也会引起室内温度的下降而不至于只降风，增加压缩机的负荷，目前的问题如过大。只有专业维修人员通过认真负责的检测，根据环境温度，电压，电流，机器的工作压力水平和出口温度、祛病的综合判断可以“对症下药”。
如果一年空调（或更少的时间）在需要添加氟化物，修复泄漏部位，然后加氟。像自行车”的*个孩子，后”。
移动空调或装修中拆除空调用户必须让专业维修人员收到空调，必须与原塞螺母挡开管嘴和嘴阀门，或用多层塑料布燕。如果水或进入土壤，后果是非常严重的。绝缘罩还及时修复受损，否则空调的能源效率也是一个很大的损失。
空调加氟的具体操作方法

网页资源有限，电源解决方案，UPS电源/蓄电池具体型号报价，技术咨询
（说出您的负载、预计延迟时间，我们专门的工程师为您配置*的电源解决方案）