HY-数显回旋振荡器 HY- Digital rotary oscillator 主要技术参 Main technical parameters 1、 电源：220V50HZ 2、 调速范围：起动~300rpm 3、 测速方式：数显 4、 调速方式：无极调速 5、 振荡幅度：2mm 6、 外形尺寸：430×430×220mm 7、 工作室尺寸：430×430×70mm 8、 夹具形式：万用弹簧夹具 9、 机械定时:定时范围,0-120分 1、 Power supply: 220V 50Hz 2、 Speed range: 0~300rpm 3、 Speed test mode: digital display 4、 Speed regulation mode: stepless 5、 Oscillation amplitude:2mm 6、 Overall dimension: 430×430×220mm 7、 Inside dimension: 430×430×70mm 8、 Clamp: universal spring clamp 9、 Timing range: 0-120min 使用方法Use method 接通电源，将需要做实验的试瓶（杯）在万用弹簧夹具上夹好，根据需要将近定时器旋钮调至适当时限或置于常开位置，打开电源开关，将调速旋钮由慢到快调至理想速度，即可正常工作。 After power-on, put the trial jars （cup） onto spring clamp and clamp them compley, then make an alternative that rotate the timing knob to desire value or turn to normal open position, turn on the power switch and turn the speed knob to desire value for normal work. 注意事项 Points for attention 使用时请保持妥善接地，以免发生意外，使用完毕，要保持机体的清洁，将所有开关或旋钮调至zui低位或关闭装态，以便于下次使用时开机后能正常操作，请不要把手置于振荡盘和箱体的接合部以免伤害，如在使用过程中出现运转不正常等现象请及时和厂方，以便尽快解决问题，确保实验的正常进行。 When under running mode, a good grounding connection is suggested to be kept so that accident can be avoided. After operation, clean the whole machine and turn off all the switches and turn the knobs to minimum or off state so that the machine can be used normally for the next time. In addition, please do not place your hand at the joint between the oscillation pan and case in case cause injury to our figure. If abnormal running occurs during operation, please contact our factory in time so that find a quick solution and ensure the test can be continued.
