派克T6H系列混和泵
T6H系列混和泵
混合泵的组合固定排量叶片泵B,C,D墨盒
结合一个变量墨盒PV20或PV29活塞泵。墨盒是由
一个共同的轴之间没有耦合的他们有一个大常见的吸入口和两个
三个独立的出口港口:一个活塞,一个或两个叶片泵
这些泵有非常紧凑的位移,在所有实际的泵的大小
市场。
T6H20B = 42,9 ml/rev variable + 5,8 to 50,0 ml/rev fixed
T6H20C = 42,9 ml/rev variable + 10,8 to 100,0 ml/rev fixed
T6H29B = 61,9 ml/rev variable + 5,8 to 50,0 ml/rev fixed
T6H29C = 61,9 ml/rev variable + 10,8 to 100,0 ml/rev fixed
T6H29D = 61,9 ml/rev variable + 47,6 to 158,0 ml/rev fixed
T6H29DB = 61,9 ml/rev variable + 47,6 to 158,0 ml/rev fixed + 5,8 to 50,0 ml/rev fixed
连续压力等级变量位移单位T6H20B / C和240条
1. Check speed range, pressure, temperature, fluid quality, viscosity and pump rotation.
2. T6H pump case pressure should not exceed 0,7 bar (see datas).
3. Check inlet conditions of the pump, if it can accept application requirement.
4. Type of shaft : if it would support operating torque.
5. Coupling must be chosen to minimize pump shaft load (weight, misalignment).
6. Filtration : must be adequate for lowest contamination level.
7. Environment of pump : to avoid noise reflection, pollution and shocks.
8. Although the T6H pumps have fast off stroke compensator reponse, system relief
valves are recommended for safety considerations.
9. When constantly under pressure with no flow requirements, it is safer to flush the piston
pump. Three drains holes are there for this purpose.
